The Cisco 200-125 research guide from Pass4sure are presented in two formats---PDF and TEST ENGINE. The Pdf files can be printed so that you can could preview your Cisco Cisco simulated materials everywhere if you carry these people with an individual. The analyze engine may be downloaded for free when you obtain our Cisco exam dumps. Pass4sure offers you the most current, dependable and genuine Cisco 200-125 practice questions which along with precise and rectified answers.
Q191. DRAG DROP - (Topic 4)
Q192. - (Topic 4)
A router has learned three possible routes that could be used to reach a destination network. One route is from EIGRP and has a composite metric of 20514560. Another route is from OSPF with a metric of 782. The last is from RIPv2 and has a metric of 4. Which route or routes will the router install in the routing table?
A. the OSPF route
B. the EIGRP route
C. the RIPv2 route
D. all three routes
E. the OSPF and RIPv2 routes
Q193. - (Topic 5)
What levels will be trapped if the administrator executes the command
router(config)# logging trap 4 (Choose four)
Q194. - (Topic 4)
Which three elements must be used when you configure a router interface for VLAN trunking? (Choose three.)
A. one physical interface for each subinterface
B. one IP network or subnetwork for each subinterface
C. a management domain for each subinterface
D. subinterface encapsulation identifiers that match VLAN tags
E. one subinterface per VLAN
F. subinterface numbering that matches VLAN tags
Q195. - (Topic 9)
Which NAT function can map multiple inside addresses to a single outside address?
Q196. - (Topic 4)
What is the default maximum number of equal-cost paths that can be placed into the routing table of a Cisco OSPF router?
Q197. - (Topic 2)
Which command can be used from a PC to verify the connectivity between hosts that connect through a switch in the same LAN?
A. ping address
B. tracert address
C. traceroute address
D. arp address
Q198. - (Topic 4)
Refer to the exhibit.
Assuming that the entire network topology is shown, what is the operational status of the interfaces of R2 as indicated by the command output shown?
A. One interface has a problem.
B. Two interfaces have problems.
C. The interfaces are functioning correctly.
D. The operational status of the interfaces cannot be determined from the output shown.
Q199. - (Topic 1)
Refer to the exhibit.
What two results would occur if the hub were to be replaced with a switch that is configured with one Ethernet VLAN? (Choose two.)
A. The number of collision domains would remain the same.
B. The number of collision domains would decrease.
C. The number of collision domains would increase.
D. The number of broadcast domains would remain the same.
E. The number of broadcast domains would decrease.
F. The number of broadcast domains would increase.
Q200. - (Topic 4)
What is the effect of using the service password-encryption command?
A. Only the enable password will be encrypted.
B. Only the enable secret password will be encrypted.
C. Only passwords configured after the command has been entered will be encrypted.
D. It will encrypt the secret password and remove the enable secret password from the configuration.
E. It will encrypt all current and future passwords.
To know more about the 200-125, click here.