We have professional as well as dedicated This experts whove rich experience in compiling your Cisco Cisco exam braindumps. They will instruct one to well get ready for the Cisco 200-125 exam. And you may also visit our interactive forum at Exambible home page. You will find many beneficial tips as well as suggestions there. Because a great number of people have passed your exam after using our Cisco 200-125 practice demos. These people come again to Exambible as well as share their experience using all the candidates. Nearly all of them speak very of our Cisco Cisco 200-125 practice questions and answers. The particular precious suggestions can benefit a person a lot.
Q201. - (Topic 8)
What are three reasons that an organization with multiple branch offices and roaming users might implement a Cisco VPN solution instead of point-to-point WAN links? (Choose three.)
A. reduced cost
B. better throughput
C. broadband incompatibility
D. increased security
F. reduced latency
Q202. - (Topic 3)
What will happen if a private IP address is assigned to a public interface connected to an ISP?
A. Addresses in a private range will be not be routed on the Internet backbone.
B. Only the ISP router will have the capability to access the public network.
C. The NAT process will be used to translate this address to a valid IP address.
D. A conflict of IP addresses happens, because other public routers can use the same range.
Q203. - (Topic 7)
Refer to the exhibit.
A problem with network connectivity has been observed. It is suspected that the cable connected to switch port Fa0/9 on Switch1 is disconnected. What would be an effect of this cable being disconnected?
A. Host B would not be able to access the server in VLAN9 until the cable is reconnected.
B. Communication between VLAN3 and the other VLANs would be disabled.
C. The transfer of files from Host B to the server in VLAN9 would be significantly slower.
D. For less than a minute, Host B would not be able to access the server in VLAN9. Then normal network function would resume.
Q204. - (Topic 9)
What are two requirements for an HSRP group? (Choose two.)
A. exactly one active router
B. one or more standby routers
C. one or more backup virtual routers
D. exactly one standby active router
E. exactly one backup virtual router
Q205. - (Topic 3)
A national retail chain needs to design an IP addressing scheme to support a nationwide network. The company needs a minimum of 300 sub-networks and a maximum of 50 host addresses per subnet. Working with only one Class B address, which of the following subnet masks will support an appropriate addressing scheme? (Choose two.)
Q206. CORRECT TEXT - (Topic 7)
Answer: Corp1#conf t
Corp1(config)# access-list 128 permit tcp host 192.168.240.1 host 172.22.141.26 eq www
Corp1(config)# access-list 128 deny tcp any host 172.22.141.26 eq www
Corp1(config)# access-list 128 permit ip any any
Corp1(config-if)#ip access-group 128 out
Corp1#copy run startup-config
Q207. - (Topic 9)
Which command can you use to set the hostname on a switch?
A. switch-mdf-c1(config)#hostname switch-mdf1
B. switch-mdf-c1>hostname switch-mdf1
C. switch-mdf-c1#hostname switch-mdf1
D. switch-mdf-c1(config-if)#hostname switch-mdf1
Q208. - (Topic 6)
Which statement about access lists that are applied to an interface is true?
A. You can place as many access lists as you want on any interface.
B. You can apply only one access list on any interface.
C. You can configure one access list, per direction, per Layer 3 protocol.
D. You can apply multiple access lists with the same protocol or in different directions.
Q209. - (Topic 4)
Which statements describe the routing protocol OSPF? (Choose three.)
A. It supports VLSM.
B. It is used to route between autonomous systems.
C. It confines network instability to one area of the network.
D. It increases routing overhead on the network.
E. It allows extensive control of routing updates.
F. It is simpler to configure than RIP v2.
Q210. - (Topic 4)
Users on the 172.17.22.0 network cannot reach the server located on the 172.31.5.0 network. The network administrator connected to router Coffee via the console port, issued the show ip route command, and was able to ping the server.
Based on the output of the show ip route command and the topology shown in the graphic, what is the cause of the failure?
A. The network has not fully converged.
B. IP routing is not enabled.
C. A static route is configured incorrectly.
D. The FastEthernet interface on Coffee is disabled.
E. The neighbor relationship table is not correctly updated.
F. The routing table on Coffee has not updated .
To know more about the 200-125, click here.